Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE CONTROL
READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL)
CHECK HARNESS AND CONNECTOR (STARTER RELAY [ST] - ECM)
ECD SYSTEM (w/o DPF) - Starter Signal Circuit
DESCRIPTION
While the engine is being cranked, current flows from terminal ST2 of the ignition switch to the park/neutral position switch and also flows to terminal STA of the ECM (STA Signal).
WIRING DIAGRAM
Refer to DTC P0617 ().
INSPECTION PROCEDURE
- NOTICE:
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
After replacing the ECM, the new ECM needs registration () and initialization ().
- HINT:
- This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to Problem Symptoms Table ().
| 1.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine / Data List / Starter Signal.
Read the value.
- OK:
Ignition Switch Condition Starter Signal ON OFF START ON
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STARTER RELAY [ST] - ECM) |
Remove the ST relay from the engine room relay block.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection Condition Specified Condition ST relay terminal 2 - A38-48 (STA) Always Below 1 Ω for RHD Tester Connection Switch Condition Specified Condition ST relay terminal 2 - A52-48 (STA) Always Below 1 Ω
Reinstall the starter relay (ST).
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||