Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE CONTROL
ECD SYSTEM (w/ DPF) - CHECK MODE PROCEDURE
- HINT:
- GTS only:
- Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.
- NOTICE:
- All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the engine switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.
| CHECK MODE PROCEDURE |
Check that the following conditions are met:
Battery positive voltage is 11 V or higher.
Transmission is in neutral.
A/C is switched off.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check for DTCs and freeze frame data using the GTS.
After checking for DTCs, inspect the applicable circuits.