Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE CONTROL
CHECK WHETHER DTC OUTPUT RECURS
DTC P2610 ECM / PCM Internal Engine Off Timer Performance
DESCRIPTION
The soak timer operates after the engine switch is turned off. When a certain amount of time has elapsed after turning the engine switch off, the soak timer activates the ECM to perform malfunction checks which can only be performed after the engine is stopped. The soak timer is built into the ECM.
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| - | ECM internal malfunction (2 trip detection logic). | ECM |
MONITOR DESCRIPTION
While the engine is running, the ECM monitors the synchronization of the soak timer and the CPU clock. If these two are not synchronized, the ECM interprets this as a malfunction, illuminates the MIL and stores the DTC.
If the soak timer activates the ECM even though only a short amount of time has elapsed since the engine switch was turned off, or if the soak timer does not activate the ECM even though a considerable amount of time has elapsed since the engine switch was turned off, the ECM determines that the soak timer is malfunctioning, illuminates the MIL and stores a DTC the next time the engine switch is turned to on (IG).
INSPECTION PROCEDURE
- NOTICE:
After replacing the ECM, the new ECM needs registration () and initialization ().
After replacing the fuel supply pump assembly, the ECM needs initialization ().
After replacing an injector assembly, the ECM needs registration ().
- HINT:
DTC P2610 is stored if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is necessary.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1.REPLACE ECM |
Replace the ECM ().
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs ().
Start the engine and wait for 10 minutes or more.
Enter the following menus: Engine and ECT / Trouble Codes / Pending.
If no pending DTC is output, the repair has been successfully completed.
| NEXT | ||
| ||