Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE CONTROL
DTC P060E Internal Control Module Throttle Position Performance
DESCRIPTION
The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. As the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals deviate, a DTC is stored.
DTC No. | DTC Detection Condition | Trouble Area |
P060E | Either condition is met (1 trip detection logic): There is an ECM main CPU error. There is an ECM sub CPU error. | ECM |
CONFIRMATION DRIVING PATTERN
INSPECTION PROCEDURE
1.CHECK FOR DTC |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear DTCs ().
Turn the GTS off.
Turn the engine switch off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check for DTCs.
- OK:
- P060E is not output.
|
| ||||
OK | ||
|