Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE CONTROL
CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0606, P0607 AND/OR P1611)
CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
DTC P0606 ECM / PCM Processor
DTC P0607 Control Module Performance
DTC P1611 IC Circuit Malfunction
DESCRIPTION
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 1 second | ECM internal error continues for 1 second (1 trip detection logic). | ECM |
INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration () and initialization ().
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0606, P0607 AND/OR P1611) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
| P0606, P0607 or P1611 is output | A |
| P0606, P0607 or P1611 and other DTCs are output | B |
|
| ||||
| A | |
| 2.REPLACE ECM |
Replace the ECM ().
| NEXT | |
| 3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs ().
Turn the ignition switch off.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||