Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 3UR-FE ENGINE MECHANICAL
DRIVE BELT - INSTALLATION
| 1. INSTALL FAN AND GENERATOR V BELT |
Set the V belt onto every part.
While turning the belt tensioner counterclockwise, remove the bar.
| *1 | Vane Pump |
| *2 | Water Pump |
| *3 | No. 1 Idler |
| *4 | Fan |
| *5 | Generator |
| *6 | Belt Tensioner |
| *7 | Crankshaft |
| *8 | Cooler Compressor |
- NOTICE:
- Make sure that the V belt is properly set to each pulley.
After installing the belt, check that it fits properly in the ribbed grooves.
| *a | CORRECT |
| *b | INCORRECT |
- HINT:
- Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
| 2. INSTALL V-BANK COVER SUB-ASSEMBLY |
Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
| *1 | Bracket |
| *2 | Hook |
| *3 | Pin |
| *4 | Grommet |
| 3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Install the No. 1 engine under cover with the 10 bolts.
- Torque:
- 29 N*m{ 296 kgf*cm, 21 ft.*lbf}
| 4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Push in the clip to install the front fender splash shield sub-assembly LH.
Install the 3 bolts and screw.
| 5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Push in the clip to install the front fender splash shield sub-assembly RH.
Install the 3 bolts and 2 screws.