Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - CRUISE CONTROL
CRUISE CONTROL SYSTEM - FAIL-SAFE CHART
- HINT:
- If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.
Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
w/o Multi-information Display Cruise control indicator light illuminates in yellow w/ Multi-information Display Cruise control indicator light turns off "CHECK CRUISE CONTROL SYSTEM" is displayed on the multi-information display in the combination meter | There is an open or short in the stop light switch circuit There is a problem with the vehicle speed signal | Turn the cruise control main switch on again |
Cruise control indicator light goes off | There is a problem with the throttle position sensor and the motor*1 There is a problem with the fuel injection system*2 | Turn the cruise control main switch on again |
w/o Multi-information Display Cruise control indicator light illuminates in yellow w/ Multi-information Display Cruise control indicator light turns off | There is a problem with the input circuit of the stop light switch circuit There is a problem with the cancel circuit | Turn the ignition switch off |
Cruise control indicator light remains on (Cruise control is canceled) | Under the following conditions, the stored vehicle speed is maintained: The vehicle speed is less than the low speed limit (approx. 40 km/h (25 mph)) while running with the cruise control on The VSC system is operated A cancel request is received from the 4WD system | Push the cruise control main switch to +RES |
The vehicle speed is less than the stored speed by approx. 16 km/h (10 mph) or more | Push the cruise control main switch to -SET |
- HINT:
*1: for 1GR-FE, 1UR-FE, 3UR-FE
*2: for 1VD-FTV