CRUISE CONTROL MAIN SWITCH - REMOVAL

Use the same procedures for LHD and RHD vehicles.

The procedures listed below are for LHD vehicles.

1. PRECAUTION

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().

3. REMOVE LOWER NO. 3 STEERING WHEEL COVER

Detach the 2 claws and remove the steering wheel cover.

4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

Detach the 2 claws and remove the steering wheel cover.

5. REMOVE STEERING PAD

Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

Disconnect the horn connector.

Disconnect the 2 connectors and remove the steering pad.

When handling the airbag connector, take care not to damage the airbag wire harness.

6. REMOVE CRUISE CONTROL MAIN SWITCH

Disconnect the connector and clamp.

Remove the 2 screws.

Remove the switch.