Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - CRUISE CONTROL
CRUISE CONTROL MAIN SWITCH - INSTALLATION
- HINT:
Use the same procedures for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
| 1. INSTALL CRUISE CONTROL MAIN SWITCH |
Install the switch.
Install the 2 screws.
Connect the connector and clamp.
| 2. INSTALL STEERING PAD |
Support the steering pad with one hand.
Connect the 2 connectors to the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
- Torque:
- 8.8 N*m{ 90 kgf*cm, 78 in.*lbf}
| 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
Attach the 2 claws to install the cover.
| 4. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
Attach the 2 claws to install the cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 6. CHECK SRS WARNING LIGHT |
Check the SRS warning light ().