INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

Measure the resistance according to the value(s) in the table below.

• Standard Resistance:

• Tester Connection	Condition	Specified Condition
  1 - 2	20°C (68°F)	6.9 to 7.9 Ω

If the result is not as specified, replace the oil control valve assembly.

Connect the battery positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

• OK:

• Condition	Specified Condition
  Battery positive (+) voltage is applied	Valve moves in left arrow direction shown in the illustration
  Battery positive (+) voltage is cut off	Valve moves in right arrow direction shown in the illustration

If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.