Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - JF2A TRANSFER / 4WD / AWD
TRANSFER ASSEMBLY - INSTALLATION
| 1. INSTALL TRANSFER ASSEMBLY |
Install the transfer with the 8 bolts.
- Torque:
- 40 N*m{ 408 kgf*cm, 30 ft.*lbf}
- NOTICE:
- Take care not to damage the adaptor oil seal with the transfer input shaft spline.
| 2. INSTALL MANUAL TRANSMISSION WITH TRANSFER ASSEMBLY (for H150F) |
()
| 3. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (for AB60F) |
for 1VD-FTV:
()
for 1UR-FE:
()
for 3UR-FE:
()
| 4. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (for A750F) |
()
| 5. ADD TRANSFER OIL |
Install a new gasket onto the drain plug and then install the plug.
- Torque:
- 37 N*m{ 377 kgf*cm, 27 ft.*lbf}
Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
- NOTICE:
Add oil slowly.
Add oil a little at a time, waiting several minutes between each addition of oil.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket onto the filler plug and then install the plug.
- Torque:
- 37 N*m{ 377 kgf*cm, 27 ft.*lbf}
Install the lower transfer case protector with the 7 bolts.
- Torque:
- 14 N*m{ 139 kgf*cm, 10 ft.*lbf}
Install the transfer heat insulator with the 4 bolts.
- Torque:
- 30 N*m{ 306 kgf*cm, 22 ft.*lbf}
except 1GR-FE:
Install the transfer dynamic damper with the 2 bolts.
- Torque:
- 12 N*m{ 122 kgf*cm, 9 ft.*lbf}
| 6. CHECK FOR TRANSFER OIL LEAK |