Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DRIVE SHAFT / PROPELLER SHAFT
FRONT PROPELLER SHAFT ASSEMBLY - INSPECTION
| 1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY |
Using a dial indicator, measure the propeller shaft runout.
- Maximum runout:
- 0.8 mm (0.031 in.)
If the shaft runout is more than the maximum, replace the shaft.
| 2. INSPECT SPIDER BEARING |
- NOTICE:
- Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.
Check the spider bearings for wear or damage.
Check the spider bearing axial play by turning the yoke while holding the shaft tightly.
- Maximum bearing axial play:
- 0 mm (0 in.)
If the axial play is more than the maximum, replace the spider bearing.
| 3. FILL PROPELLER SHAFT WITH GREASE |
Fill each of the grease fitting holes of the propeller shaft with MP grease.
- NOTICE:
- Stop filling the grease fitting hole on the middle portion of the propeller shaft once the sliding portion starts extending.
Drive the vehicle.
- NOTICE:
- Check the safety of the surrounding areas.
- HINT:
- Move the vehicle forward and in reverse 5 times and strongly apply the brake.
Lift up the vehicle and wipe off any excess grease as a result of driving.