Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AB60F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM (for 1VD-FTV with DPF) - HOW TO PROCEED WITH TROUBLESHOOTING
- HINT:
The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
*: Use the GTS.
| 1.VEHICLE BROUGHT TO WORKSHOP |
|
| 2.CUSTOMER PROBLEM ANALYSIS |
|
| 3.INSPECT BATTERY VOLTAGE |
- Standard Voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
| 4.CONNECT GTS TO DLC3* |
|
| 5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
Refer to the DTC Check / Clear ().
|
| 6.VISUAL INSPECTION |
|
| 7.SETTING CHECK MODE DIAGNOSIS* |
Refer to the Check Mode Procedure ().
|
| 8.PROBLEM SYMPTOM CONFIRMATION |
Refer to the Road Test ().
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
|
| 9.SYMPTOM SIMULATION |
Refer to the Electronic Circuit Inspection Procedure ().
|
| 10.DTC CHECK* |
Refer to the DTC Check / Clear ().
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
|
| 11.BASIC INSPECTION |
Refer to the Park/Neutral Position Switch ().
Refer to the Shift Lever Assembly ().
|
| ||||
|
| 12.MECHANICAL SYSTEM TESTS |
Refer to the Mechanical System Tests ().
|
| ||||
|
| 13.HYDRAULIC TEST |
Refer to the Hydraulic Test ().
|
| ||||
|
| 14.MANUAL SHIFTING TEST |
Refer to the Manual Shifting Test ().
|
| ||||
|
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
Refer to the Problem Symptoms Table ().
|
| ||||
|
| 16.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
Refer to the Problem Symptoms Table ().
|
| 17.PART INSPECTION |
|
| ||||
|
| 18.DTC CHART |
Refer to the Diagnostic Trouble Code Chart ().
|
| 19.CIRCUIT INSPECTION |
|
| 20.IDENTIFICATION OF PROBLEM |
|
| 21.REPAIR OR REPLACE |
|
| 22.CONFIRMATION TEST |
| ||||
|
|---|