Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
YAW RATE AND DECELERATION SENSOR (w/ VSC) - INSTALLATION
| 1. INSTALL YAW RATE SENSOR |
Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.
- NOTICE:
- Securely connect the connector.
Install the yaw rate sensor with the 2 bolts.
- Torque:
- 15 N*m{ 148 kgf*cm, 11 ft.*lbf}
- NOTICE:
Make sure that the sensor is oriented correctly.
If the sensor is dropped, replace it.
When installing the sensor, make sure to avoid impacts to the sensor.
| 2. INSTALL COOLING BOX ASSEMBLY (w/ Cool Box) |
()
| 3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box) |
()
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION |
Perform the yaw rate sensor zero point calibration ().
| 6. CHECK YAW RATE SENSOR SIGNAL |
Check the yaw rate sensor signal ().