VEHICLE STABILITY CONTROL SYSTEM - CHECK FOR INTERMITTENT PROBLEMS

DESCRIPTION

HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected through the ECU data monitor function of the GTS.

Turn the ignition switch off.

Connect the GTS to the DLC3.

Turn the ignition switch to ON.

Turn the GTS on.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

Select areas where momentary interruptions should be monitored.

HINT:

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

If Error is displayed, check for continuity between the ECUs and the sensors or between ECUs.

Error remains displayed on the GTS for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal.

ABS/VSC/TRC
Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
FR Speed Open	Front speed sensor RH open circuit detection/ Error or Normal	Normal	-
FL Speed Open	Front speed sensor LH open circuit detection/ Error or Normal	Normal	-
RR Speed Open	Rear speed sensor RH open circuit detection/ Error or Normal	Normal	-
RL Speed Open	Rear speed sensor LH open circuit detection/ Error or Normal	Normal	-
EFI Communication Open	ECM communication open circuit detection/ Error or Normal	Normal	-
Yaw Rate Open	Yaw rate sensor open circuit detection/ Error or Normal	Normal	-
Deceleration Open	Acceleration sensor open circuit detection/ Error or Normal	Normal	-
Steering Open	Steering sensor open circuit detection/ Error or Normal	Normal	-
Master Cylinder Open	Master cylinder pressure sensor open circuit detection/ Error or Normal	Normal	-
IG Voltage Value Decreased	IG voltage value decreased detection/ Error or Normal	Normal	-
IG Voltage Value Increased	IG voltage value increased detection/ Error or Normal	Normal	-
FR Speed Sensor Voltage Open	Front speed sensor RH voltage open circuit detection/ Error or Normal	Normal	-
FL Speed Sensor Voltage Open	Front speed sensor LH voltage open circuit detection/ Error or Normal	Normal	-
RR Speed Sensor Voltage Open	Rear speed sensor RH voltage open circuit detection/ Error or Normal	Normal	-
RL Speed Sensor Voltage Open	Rear speed sensor LH voltage open circuit detection/ Error or Normal	Normal	-
M/C Pressure Sensor Noise	Master cylinder pressure sensor noise detection/ Error or Normal	Normal	-
Yaw Rate Sensor Voltage Open	Yaw rate sensor voltage open circuit detection/ Error or Normal	Normal	-
EFI Communication Invalid	ECM communication invalid detection/ Error or Normal	Normal	-

While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors or between ECUs.

OK:
Normal display appears.

NOTICE:

The connector and/or wire harness has a momentary interruption (open circuit) if the display changes. Repair or replace the connectors and/or wire harnesses as one of them is faulty.

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS

Land Cruiser URJ200 URJ202 GRJ200 VDJ200

VEHICLE STABILITY CONTROL SYSTEM