Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)

RECONFIRM DTC

DTC C1417 High Power Supply Voltage Malfunction

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.


This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.


This DTC is cleared when the IG1 terminal voltage returns to normal.

DTC CodeDTC Detection ConditionTrouble Area
C1417The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
Charging system
Power source circuit
Internal power supply circuit of the skid control ECU (master cylinder solenoid)

WIRING DIAGRAM

Refer to DTC C1241 ().


INSPECTION PROCEDURE

  • NOTICE:
  • After replacing the master cylinder solenoid, perform zero point calibration and store the system information ().
1.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)

Disconnect the skid control ECU (master cylinder solenoid) connector.

Dtc C1417  High Power Supply Voltage Malfunction. BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS. Land Cruiser URJ200  URJ202 GRJ200 VDJ200

Measure the voltage according to the value(s) in the table below.

  • Standard Voltage:
  • Tester ConnectionConditionSpecified Condition
    A24-46 (IG1) - Body groundIgnition switch ON
    (Engine running)
    11 to 14 V
Text in Illustration
*aFront view of wire harness connector
(to Skid Control ECU [Master Cylinder Solenoid])
Result
ResultProceed to
OKA
NG (for 1VD-FTV)B
NG (for 1UR-FE)C
NG (for 3UR-FE)D
B
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) ()
C
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) ()
D
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) ()
A
2.RECONFIRM DTC

Clear the DTC ().

Turn the ignition switch off.

Check if the same DTC is output ().

Result
ResultProceed to
DTC is not outputA
DTC is output (for LHD)B
DTC is output (for RHD)C
B
REPLACE MASTER CYLINDER SOLENOID ()
C
REPLACE MASTER CYLINDER SOLENOID ()
A
CHECK FOR INTERMITTENT PROBLEMS ()