DTC C1290 Steering Angle Sensor Zero Point Malfunction

DESCRIPTION

The skid control ECU (master cylinder solenoid) acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The skid control ECU (master cylinder solenoid) also stores the previous zero point.

If the front wheel alignment or steering wheel position is adjusted without disconnecting the cable from the negative (-) battery terminal, or if the yaw rate and acceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU (master cylinder solenoid) detects the difference between the previous zero point and newly acquired zero point and stores this DTC to indicate poor adjustment.

The steering angle sensor zero point malfunction warning is canceled by turning the ignition switch off.

DTC Code	DTC Detection Condition	Trouble Area
C1290	The steering angle sensor zero point calibration position vastly differs from the recorded value.	Yaw rate and acceleration sensor zero point calibration incomplete Poor adjustment of the centered position of the steering wheel Poor adjustment of front wheel alignment

INSPECTION PROCEDURE

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR

Perform zero point calibration of the yaw rate and acceleration sensor ().

HINT:

When the stored zero point of the yaw rate and acceleration sensor is cleared, steering angle sensor zero point is also cleared.

If the zero point and output value of the yaw rate and acceleration sensor and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 35 km/h (22 mph) or more.

NEXT

2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.

Check that the centered position of the steering wheel is correctly set while driving straight ahead.

HINT:

If the front wheel alignment and steering position are adjusted as a result of an abnormal centered position of the steering wheel, acquire the yaw rate and acceleration sensor zero point again after the adjustments are completed.

OK:
The centered position of the steering wheel is correctly set.

NG

ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION ()

OK

END

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS

Land Cruiser URJ200 URJ202 GRJ200 VDJ200

VEHICLE STABILITY CONTROL SYSTEM