Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
DECELERATION SENSOR (w/ ABS) - INSTALLATION
| 1. INSTALL DECELERATION SENSOR (for Automatic Transmission) |
Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.
- NOTICE:
- Securely connect the connector.
Install the sensor with the 2 bolts.
- Torque:
- 15 N*m{ 148 kgf*cm, 11 ft.*lbf}
- NOTICE:
Make sure that the sensor is oriented correctly.
If the sensor is dropped, replace it.
When installing the sensor, make sure to avoid impacts to the sensor.
| 2. INSTALL DECELERATION SENSOR (for Manual Transmission) |
Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.
Install the sensor with the 2 bolts.
- Torque:
- 15 N*m{ 148 kgf*cm, 11 ft.*lbf}
- NOTICE:
Make sure that the sensor is oriented correctly.
If the sensor is dropped, replace it.
Securely connect the connector.
When installing the sensor, make sure to avoid impacts to the sensor.
| 3. INSTALL LOWER CONSOLE BOX (w/o Console Box Lid) |
()
| 4. INSTALL COOLING BOX ASSEMBLY (w/ Cool Box) |
()
| 5. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box) |
()
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 7. PERFORM G SENSOR ZERO POINT CALIBRATION |
Perform the G sensor zero point calibration ().
| 8. CHECK G SENSOR SIGNAL |
Check the G sensor signal ().