Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
ANTI-LOCK BRAKE SYSTEM - PRECAUTION
| 1.EXPRESSIONS OF IGNITION SWITCH |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
| 2.TROUBLESHOOTING PRECAUTION |
When there is a malfunction in the contact point of the terminals or installation problems with parts, removal and installation of the suspected problem parts may return the system to normal either completely or temporarily.
In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as by DTC output and freeze frame data output, and record it before disconnecting each connector or removing and installing parts.
Since the Anti-lock Brake System (ABS) may be influenced by a malfunction in the other systems, be sure to check for DTCs in the other systems.
Be sure to remove and install the hydraulic brake booster and each sensor with the ignition switch off unless specified in the inspection procedure.
When removing and installing the hydraulic brake booster and each sensor, be sure to check that the normal display is output in test mode inspection and in DTC output inspection after installing all the parts.
After replacing the master cylinder solenoid and/or the deceleration sensor, make sure to perform deceleration sensor zero point calibration ().
The CAN communication system is used for data communication between the skid control ECU (included in the master cylinder solenoid), ECM, four wheel drive control ECU, combination meter and DLC3. If there is trouble in the CAN communication line, the DTC of the communication line is stored.
If the DTC of the CAN communication line is stored, repair the malfunction in the communication line first and then troubleshoot the anti-lock brake system.
Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
w/ Rear Differential Lock:
When the rear differential is locked, the ABS does not operate but the EBD operates.
When the rear differential is locked, the ABS does not operate but the EBD operates.