TELEVISION CAMERA (for Side) - INSTALLATION

Attach the 2 guides and body.

• NOTICE:

• Be careful not to break the guide.

Install the body with the 5 screws.

Attach the guide.

Using "TORX" socket wrench T25, install the base with 3 new screws.

• NOTICE:

• When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.

Attach the 4 claws and install the new lower mirror cover.

Attach the 9 guides and install the gasket.

Align the marking on the wire harness with the marking on the end of the wire harness insertion hole of the gasket as shown in the illustration, and wrap them with new vinyl tape starting from the gasket marking.

• Standard:

• Area	Specified Condition
  a	50.0 mm (1.97 in.)

• NOTICE:

• If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.

Wrap new vinyl tape as shown in the illustration.

• Standard:

• Area	Specified Condition
  a	30.0 mm (1.18 in.)
  b	50.0 mm (1.97 in.)

Insert the rib on the outer edge of the cover into the groove of the mirror body.

• NOTICE:

• Do not scratch the turn light.

While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.