Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - NAVIGATION / MULTI INFO DISPLAY
HARD DISK DRIVE - PRECAUTION
| 1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL |
After the engine switch is turned off, the multi-media module receiver assembly requires approximately 60 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
| 2.PRECAUTIONS FOR MULTI-MEDIA MODULE RECEIVER ASSEMBLY |
An HDD is built into the multi-media module receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling:
| *a | Example | *b | Hard Disc |
| *c | Multi-media Module Receiver Assembly | - | - |
When it is necessary to replace the multi-media module receiver assembly, be sure to replace it with a new one.
- NOTICE:
- If a used multi-media module receiver assembly is installed as a replacement part, the customer's HDD will not be recognized.
Do not apply any vibration or shock to the multi-media module receiver assembly.
- NOTICE:
Do not remove the multi-media module receiver assembly if there is a risk that condensation may occur.
- NOTICE:
- If the temperature of the multi-media module receiver assembly changes rapidly, condensation may occur inside the unit. This may cause a malfunction of the HDD. Therefore, when the multi-media module receiver assembly is removed from the instrument panel, it needs to be kept inside the vehicle or in an environment with an equivalent temperature and humidity.
Take measures to prevent static electricity.
- NOTICE:
- Touching the terminals of a connector can cause static electricity to be transmitted to the internal circuits. This may cause a malfunction of the HDD.
Keep the multi-media module receiver assembly away from magnets or magnetized items.
- NOTICE:
- Keep the multi-media module receiver assembly away from speakers, motors, magnetized tools and other magnetic items.
| 3.PRECAUTIONS FOR HARD DISK DRIVE (HDD) |
Map and other data for the navigation system is stored on the Hard Disk Drive (HDD). Make sure to follow the following instructions when replacing the HDD:
- NOTICE:
- Data downloaded by the customer may be stored on the HDD. This data will be lost when the HDD is replaced. Make sure to warn the customer that their data will be lost and obtain their consent prior to replacing the HDD.
The HDD must only be replaced with a new one. Do not attempt to install a used HDD from another vehicle.
- NOTICE:
- The multi-media module receiver assembly can recognize only a new HDD.
Do not touch the HDD cover.
- NOTICE:
- When removing or installing the HDD, only hold it by the areas shown in the illustration.
| *a | Example |
| *b | CORRECT |
| *c | INCORRECT |
Do not apply any vibration or shock to the HDD.
- NOTICE:
Do not remove the HDD if there is a risk that condensation may occur.
- NOTICE:
- If the temperature of the HDD changes rapidly, condensation may occur inside the unit. This may cause a malfunction of the HDD. Therefore, when the multi-media module receiver assembly is removed from the instrument panel, it needs to be kept inside the vehicle or in an environment with an equivalent temperature and humidity.
Take measures to prevent static electricity.
- NOTICE:
- Touching the terminals of a connector can cause static electricity to be transmitted to the internal circuits. This may cause a malfunction of the HDD.
Keep the HDD away from magnets or magnetized items.
- NOTICE:
- Keep the HDD away from speakers, motors, magnetized tools and other magnetic items.
Inspect after HDD replacement.
- NOTICE:
- Make sure to perform Check Hard Disk Drive in Operation Check to confirm that there are no HDD abnormalities after removal or installation ().