Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AUDIO / VIDEO
FRONT DOOR SPEAKER - REMOVAL
- HINT:
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
Detach the clip and claw, and remove the front door lower frame bracket garnish LH.
| 4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH |
Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.
- HINT:
- Tape the screwdriver tip before use.
| *1 | Protective Tape |
| 5. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH |
Using a moulding remover, detach the 5 claws.
Disconnect the connector and remove the armrest base panel.
| 6. REMOVE DOOR ASSIST GRIP COVER LH |
Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.
| 7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the 3 screws.
Remove the 13 clips.
Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.
- HINT:
- Make sure that the pin labeled A in the illustration is detached from the door panel.
Disconnect the connector.
Disconnect the 2 cables from the front door inside handle sub-assembly LH.
| 8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY |
Disconnect the speaker connector.
Remove the 4 screws and speaker.
- NOTICE:
- Do not touch the cone part of the speaker.