Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - AUDIO / VIDEO

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CLEAR DTC

CHECK DTC

CHECK VEHICLE SENSOR (OPERATION CHECK)

DTC B15C2 Speed Signal Malfunction

DESCRIPTION

The multi-media module receiver assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna, and then adjusts the vehicle position on the map. The multi-media module receiver assembly stores this DTC when the difference between the speed information that the navigation antenna assembly receives and the SPD pulse received from the combination meter assembly becomes large.


  • HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
DTC CodeDTC Detection ConditionTrouble Area
B15C2A difference between the GPS speed and SPD pulse is detected
Combination meter assembly
Multi-media module receiver assembly
Harness or connector

WIRING DIAGRAM

Dtc B15C2 Speed Signal Malfunction. AUDIO / VIDEO. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

INSPECTION PROCEDURE

1.CLEAR DTC

Clear the DTCs ().

NEXT
2.CHECK DTC

Recheck for DTCs and check if the same DTC is output again ().

  • OK:
  • No DTCs are output.
NG
Go to step 3
OK
USE SIMULATION METHOD TO CHECK ()
3.CHECK VEHICLE SENSOR (OPERATION CHECK)
Dtc B15C2 Speed Signal Malfunction. AUDIO / VIDEO. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensor in Operation Check ().

While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

  • HINT:
  • The combination meter assembly receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.
  • OK:
  • Vehicle speed displayed on the "Vehicle Sensors" screen is almost the same as the actual vehicle speed measured using the intelligent tester ().
NG
GO TO METER / GAUGE SYSTEM ()
OK
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY ()
AUDIO / VIDEO
Land Cruiser URJ200 URJ202 GRJ200 VDJ200
AUDIO AND VISUAL SYSTEM w/ Navigation System