DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
AUDIO AND VISUAL SYSTEM (w/ Navigation System) - Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the multi-media module receiver assembly via this circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the F86 multi-media module receiver assembly connector.
Disconnect the z62 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
| Tester Connection | Condition | Specified Condition |
| F86-2 (US1-) - z62-3 (UDI+) | Always | Below 1 Ω |
| F86-3 (US1+) - z62-2 (UDI-) | Always | Below 1 Ω |
| F86-5 (USG1) - z62-5 (UJSS) | Always | Below 1 Ω |
| F86-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| F86-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| F86-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK | |
| |
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE ()
|
|