INSPECTION PROCEDURE
CHECK CONDITION
CHECK MICROPHONE (OPERATION CHECK)
REPLACE HARD DISC
AUDIO AND VISUAL SYSTEM (w/ Navigation System) - Voice is not Recognized
INSPECTION PROCEDURE
Refer to the owner's manual and follow its instructions to check that the voice recognition level of the system is not too low for a particular voice.
Result| Result | Proceed to |
| System voice recognition level is low with any voice. | A |
| System voice recognition level is low only for a particular voice. | B |
- System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.
| 2.CHECK MICROPHONE (OPERATION CHECK) |
Enter the "Microphone&Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check ().
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Select the recording switch and perform voice recording.
Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
| | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE ()
|
|
|
Replace the hard disc ().
Check that voice recognition is normal.
- OK:
- Voice can be recognized normally.
| | REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY ()
|
|
|
| OK | |
| |
| END (HARD DISC IS DEFECTIVE) |
|
