Land Cruiser Prado GRJ150 TRJ150 TRJ155 KDJ150 TRJ155 LJ150 - ТОПЛИВНАЯ СИСТЕМА ДВИГАТЕЛЯ 5L-E
INSPECT INJECTION PUMP
INSPECT TIMING CONTROL VALVE
INSPECT INJECTION PUMP DELIVERY VALVE SUB-ASSEMBLY
ТОПЛИВНЫЙ НАСОС ВЫСОКОГО ДАВЛЕНИЯ - ПРОВЕРКА
| 1. INSPECT INJECTION PUMP |
Inspect the engine speed sensor.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (NE-) - 2 (NE+) 20°C (68°F) 205 to 255 Ω
If the result is not as specified, replace the injection pump assembly.
Inspect the spill control valve.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (SPV-) - 2 (SPV+) 20°C (68°F) 1 to 2 Ω
If the result is not as specified, replace the injection pump assembly.
Inspect the fuel temperature sensor.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (E2) - 2 (THF) 20°C (68°F) 2.21 to 2.69 kΩ
- ПРИМЕЧАНИЕ:
- When checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.
If the result is not as specified, replace the injection pump assembly.
| 2. INSPECT TIMING CONTROL VALVE |
Inspect the timing control valve.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (+B) - 2 (TCV) 20°C (68°F) 10 to 14 Ω
If the result is not as specified, replace the timing control valve.
Inspect the timing control valve operation.
- ПРИМЕЧАНИЕ:
Connect the positive (+) lead of the battery to the timing control valve +B terminal.
Connect the negative (-) lead of the battery to the timing control valve TCV terminal.
Check that the solenoid makes a "click" sound.
If the result is not as specified, replace the timing control valve.
| 3. INSPECT INJECTION PUMP DELIVERY VALVE SUB-ASSEMBLY |
- ПРИМЕЧАНИЕ:
- Do not touch the sliding surface of the delivery valves.
Pull up the valve and release it. Check that it sinks smoothly into the valve seat. If the operation is not as specified, replace the valve and valve seat as a set.
- УКАЗАНИЕ:
- Before using a new valve set, wash off the rust prevention compound with diesel fuel. Then rewash with diesel fuel and perform the above test.