СИСТЕМА ПРЕДПУСКОВОГО ПОДОГРЕВА - ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

1. INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT

Turn the ignition switch to the ON position, and measure the lighting time.

2. INSPECT PRE-HEATING

Turn the ignition switch to the ON position, measure the time when the battery voltage is applied to the glow plugs.

Pre-Heating time:
Engine coolant temperature Pre-Heating time
40°C or more 1 sec.
40°C or less Refer to the chart graph (15 sec. at the longest)

Turn the ignition switch to the START position, and check the battery voltage is applied to the glow plugs.

While cranking the engine, measure the time when the battery voltage is applied to the glow plugs.

Pre-Heating time:
Engine coolant temperature Pre-Heating time
40°C or more 1 sec.
40°C or less Refer to the chart graph (15 sec. at the longest)

3. INSPECT AFTER GLOW TIME

After starting the engine starting, measure the time when the battery voltage is applied to the terminal SREL of the ECM.

4. INSPECT GLOW PLUGS

Using an ohmmeter, measure the resistance between the glow plug terminal and ground.

Do not damage the glow plug pipes as it could cause an open circuit or shorten life of the glow plugs.

Avoid getting oil and gasoline on the glow plug when cleaning.

During inspection, be sure to wipe any oil on the terminal and bakelite washer with a dry cloth.

Do not apply more than 11 V to the glow plug as it could cause an open circuit.

Engine coolant temperature	Pre-Heating time
40°C or more	1 sec.
40°C or less	Refer to the chart graph (15 sec. at the longest)