МАСЛЯНЫЙ НАСОС - СНЯТИЕ

Remove the engine (See page ).

Remove the 4 bolts and compressor mounting bracket.

Remove the timing belt (See page ).

Remove the injection pump (See page ).

Remove the 3 bolts, outlet housing and gasket.

Remove the water by-pass hose union.

Remove the 3 bolts and pump bracket.

Remove the 4 bolts and engine mounting bracket.

Remove the 4 bolts and engine mounting bracket.

Remove the 3 bolts and No. 1 generator bracket.

Using the crankshaft pulley bolt, turn the crankshaft 90° counterclockwise and align the timing mark of the crankshaft timing pulley with the protrusion of the timing belt case.

Text in Illustration

	Turn
*1	Timing Mark
*2	Protrusion

• УКАЗАНИЕ:

• Set the No. 1 cylinder to 90° BTDC/compression to avoid interference with the piston top and valve head.

Using SST, loosen the pulley bolt.

• SST
• 09960-10010(09962-01000,09963-01000)

Using SST, separate the timing pulley from the camshaft.

• SST
• 09950-50013(09951-05010,09952-05010,09953-05010,09954-05021)

Remove the pulley bolt and timing pulley.

Remove the timing pulley woodruff key.

Remove the 4 bolts and timing belt cover.

Remove the 6 bolts and tension spring bracket.

Remove the water pump and gasket.

Remove the 2 bolts (A and B).

Loosen the bolt (C), and remove the No. 1 timing belt idler.

Remove the bolt, No. 2 timing belt idler and spacer.

Using a screwdriver, remove the crankshaft timing pulley.

• SST
• 09950-50013(09951-05010,09952-05010,09953-05010,09953-05020,09954-05010)

• УКАЗАНИЕ:

• If the timing pulley cannot be removed by using a screwdriver, remove it with SST.

Remove the 16 bolts and 2 nuts.

Insert the blade of an oil pan seal cutter between the oil pan and cylinder block, cut off the applied sealer and remove the oil pan.

• ПРИМЕЧАНИЕ:

Remove the 2 bolts, 2 nuts, oil strainer and gasket.

Remove the 5 bolts, timing belt case and gasket.

Using a screwdriver, pry out the oil seal.

• ПРИМЕЧАНИЕ:

• Tape the screwdriver tip before use.