Lexus IS250 IS220d GSE20 ALE20 A960E AUTOMATIC TRANSMISSION

Perform this drive pattern as one method to simulate the detection conditions of the ECT malfunctions. (The DTCs may not be detected due to the actual driving conditions. And some codes may not be detected through this drive pattern.)

Turn the engine switch off.

Disconnect the connector of the transmission wire.

Measure the line pressure.

Measure the stall speed.

The object of this test is to check the overall performance of the transmission and engine by measuring the stall speeds in the D position.

Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up, shift down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and simulate the problem symptoms.

If the voltage is below 11 V, recharge or replace the battery before proceeding.

The ECT (Electronic controlled automatic transmission) is an automatic transmission that electronically controls shift timing using the ECM. The ECM detects electrical signals that indicate engine and driving conditions, and controls the shift point, based on driver habits and road conditions. As a result, fuel efficiency and power transmission performance are improved.

Shift shock has been reduced by controlling the engine and transmission simultaneously.

The configuration of the electronic control system in the A960E automatic transmission is as shown in the following chart.