Land Cruiser URJ200 URJ202 GRJ200 VDJ200 SUSPENSION CONTROL

Before removing, installing and disassembling hydraulic circuit parts, clean each part to prevent mud and dirt from entering the hydraulic circuit.

With the engine stopped, fill the reservoir tank with fluid.

With the vehicle empty, after setting the vehicle height to NORMAL from LO, check the indicator to make sure the vehicle height is NORMAL and check that the fluid level in the reservoir tank is within the specified range (MAX, MIN).

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 SUSPENSION CONTROL

Land Cruiser URJ200 URJ202 GRJ200 VDJ200 SUSPENSION CONTROL

Connect the intelligent tester to the DLC3.

Remove the suspension control relay from the engine room relay block.

This relay is to supply the power source to the pump and motor. The relay stays on while the height control is operated.

The control valve solenoid assembly consists of each front and rear leveling valve, gate valve and accumulator valve. It performs the height control and connects and disconnects the fluid line of the right and left shock absorber by operating the solenoid valve with the control signal from the ECU.