Parking Brake Cable Installation

Install the cable with the 4 bolts and nut as shown in the illustration.

Torque:

26 N*m{260 kgf*cm, 19 ft.*lbf}

Install the No. 3 clip as shown in the illustration.

Connect the cable to the parking brake shoe lever LH and backing plate LH.

1. Connect the cable to the backing plate with the 2 bolts.
   

   Torque:

   9.0 N*m{92 kgf*cm, 80 in.*lbf}

2. Connect the cable to the lever (Toyota Fortuner RM000001HJY005X.html).
   

Install the cable with the 4 bolts as shown in the illustration.

Torque:

26 N*m{260 kgf*cm, 19 ft.*lbf}

Connect the cable to the parking brake shoe lever RH and backing plate RH.

1. Connect the cable to the backing plate with the 2 bolts.
   

   Torque:

   9.0 N*m{92 kgf*cm, 80 in.*lbf}

2. Connect the cable to the lever (Toyota Fortuner RM000001HJY005X.html).
   

Connect the cable to the equalizer as shown in the illustration.

Install the No. 2 heat insulator with the 3 bolts.

Torque:

26 N*m{260 kgf*cm, 19 ft.*lbf}

Connect the cable to the parking brake lever (Toyota Fortuner RM000001HKA008X.html).

Install the cable with the bolt.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Connect the cable to the equalizer.

Connect the cable to the No. 3 cable.

Install the pin and No. 1 clip.

Attach the cable to the cable support bracket.

Install the No. 1 heat insulator with the 2 bolts.

Torque:

6.0 N*m{61 kgf*cm, 53 in.*lbf}

Check that each part is installed properly.

Measure the inside diameter of the drum and the diameter of the shoes. Check that the difference between the diameters is the standard shoe clearance.

Standard shoe clearance:

0.6 mm (0.024 in.)

NOTICE:

There should be no oil or grease on the contact surfaces of the shoe lining and drum.

Pull the lever upward with a force of approximately 200 N (20 kgf, 45 lbf) and count the number of clicks.

OK:

7 to 9 clicks (without rear brake dragging)

Turn the No. 1 wire adjusting nut until the lever travel is correct.

OK:

7 to 9 clicks (without rear brake dragging)
<Lever pulling force: approximately 200 N (20 kgf, 45 lbf)>

Tighten the lock nut.

Torque:

5.2 N*m{53 kgf*cm, 46 in.*lbf}

HINT:

If further adjustment is necessary, proceed to the next step.

Loosen the lock nut and turn buckle until the lever travel is correct.

Tighten the lock nut.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the console box assembly (Toyota Fortuner RM000000SQF00SX.html).