Brake Master Cylinder (W/O Vsc) Installation

Apply lithium soap base glycol grease to the 2 grommets and install them to the master cylinder.

Install the reservoir with the screw.

Install a new O-ring to the master cylinder.

Install the master cylinder and bracket (with 3-way) to the booster with the 2 nuts.

Torque:

20 N*m{204 kgf*cm, 15 ft.*lbf}

Using SST, connect the 5 brake lines labeled C to the master cylinder and 3-way.

SST

09023-00101

Torque:

15.2 N*m{155 kgf*cm, 11 ft.*lbf}without SST

14 N*m{143 kgf*cm, 10 ft.*lbf}with SST

HINT:

Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

Connect the brake fluid level warning switch connector labeled B to the master cylinder.

for Manual Transmission:
Connect the clutch reservoir tube labeled A to the master cylinder.

Using SST, disconnect the 2 brake lines from the master cylinder.

SST

09023-00101

Slowly depress and hold the brake pedal.

Cover the outer holes with your fingers, and release the pedal.

Repeat the 2 previous steps 3 or 4 times.

Using SST, connect the 2 brake lines to the master cylinder.

SST

09023-00101

Torque:

15.2 N*m{155 kgf*cm, 11 ft.*lbf}without SST

14 N*m{143 kgf*cm, 10 ft.*lbf}with SST

HINT:

Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

Remove the bleeder plug cap.

Connect a vinyl tube to the bleeder plugs.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.

When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.

Repeat the 2 previous steps until all the air in the brake fluid is gone.

Tighten the bleeder plug.

Torque:

10.8 N*m{110 kgf*cm, 8 ft.*lbf}for front brake

10 N*m{102 kgf*cm, 7 ft.*lbf}for rear brake

Install the cap.

Bleed air from the brake line for each wheel by repeating the above procedures.

Remove the bleeder plug cap.

Connect a vinyl tube to the bleeder plug.

Depress the clutch pedal several times, and then loosen the bleeder plug with the pedal depressed.

At the point when fluid stops coming out, tighten the bleeder plug, and then release the clutch pedal.

Repeat the previous 2 steps until all the air in the fluid is completely bled out.

Tighten the bleeder plug.

Torque:

11 N*m{112 kgf*cm, 8 ft.*lbf}

Install the bleeder plug cap.

Check that all the air has been bled out of the clutch line.

Check the fluid level and add fluid if necessary.

Fluid:

SAE J1703 or FMVSS No. 116 DOT 3

HINT:

Add fluid to a level between the reservoir's MIN and MAX lines.