Rear Wiper Motor Installation

Apply MP grease to the entire inner surface of the wiper motor grommet.

HINT:

Make sure that grease is applied so that the grooves in the grommet are filled with grease, but not so that the hole of the grommet becomes clogged with grease.

Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

Install the wiper motor with the 3 bolts.

Torque:

8.3 N*m{85 kgf*cm, 73 in.*lbf}

Connect the connector.

Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

Clean the wiper pivot serration with a wire brush.

Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

Torque:

8.4 N*m{86 kgf*cm, 74 in.*lbf}

HINT:

1. Hold down the arm hinge by hand while tightening the nut.
   
2. Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.
   

   Text in Illustration

   *1	Ceramic Line

Operate the rear wiper while spraying water or washer fluid on the glass. Ensure that there is no interference between the blade and pillar.

Close the wiper arm head cap.

Attach the 16 clips to install the back door trim board.