Emission Control System On-Vehicle Inspection


  1. INSTALL VACUUM GAUGE

  2. CHECK SEATING OF EGR VALVE

  3. CHECK OUTPUT VACUUM WITH VACUUM GAUGE

  4. CHECK HOT ENGINE CONDITION

  5. REMOVE VACUUM GAUGE

  6. CHECK FOR LEAKS

  7. CHECK VACUUM PUMP ASSEMBLY

Emission Control System -- On-Vehicle Inspection


NOTICE:
Always stop the engine when installing or removing the vacuum gauges, or removing the vacuum hoses.
HINT:
In a malfunction where the EGR system is always on, black or white smoke may emit from the exhaust pipe.
If this occurs, inspect the EGR system.


1. INSTALL VACUUM GAUGE


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.1Kd-Ftv Emission Control.Emission Control System.Emission Control System On-Vehicle Inspection

  1. Using a 3-way connector, connect a vacuum gauge to the hose between the EGR valve and E-VRV.



2. CHECK SEATING OF EGR VALVE

  1. Start the engine. Check that the engine starts and then idles.



3. CHECK OUTPUT VACUUM WITH VACUUM GAUGE

  1. Connect a vacuum gauge to the output pipe.

  1. Warm up the engine and check that the vacuum gauge reading is above 28.0 kPa (210 mmHg, 8.3 in.Hg).
    If the result is not as specified, check for leaks between the EGR valve and vacuum pump, or check the EGR valve.



4. CHECK HOT ENGINE CONDITION

  1. Visually check the vacuum hose between the vacuum pump and EGR valve for leaks.

  1. Warm up the engine.
    The coolant temperature should be above 75°C (109°F) and below 90°C (194°F).

  1. Check that the vacuum gauge reading is more than 28.0 kPa (210 mmHg, 8.3 in.Hg) at idle.

  1. Check that the vacuum gauge indicator reading increases by more than 28.0 kPa (210 mmHg, 8.3 in.Hg) at 1,500 rpm.

  1. When the accelerator pedal is fully depressed quickly, check that the vacuum gauge indicator reading drops momentarily.

  1. Keep the engine speed at more than 4,000 rpm.

  1. Check that the vacuum gauge reading is as shown below.

    Standard condition:
    3.6 kPa (28 mmHg, 1.1 in.Hg)

  1. When the accelerator pedal is released, check that the vacuum gauge indicator reading drops momentarily while the engine speed decreases from more than 4,000 rpm to idle.
    If the result is not as specified, refer to the INSPECTION section (Toyota Fortuner RM000001418004X.html).



5. REMOVE VACUUM GAUGE


6. CHECK FOR LEAKS


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50

  1. Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

    NOTICE:
    1. Detachment or other problems with the engine oil dipstick, filler cap, PCV hose and other components may cause the engine to run improperly.
    1. Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.
    If the result is not as specified, replace parts as necessary.


7. CHECK VACUUM PUMP ASSEMBLY

  1. Check the vacuum pump (Toyota Fortuner RM0000010LK002X.html).