Front Drive Shaft Assembly Removal
REMOVE FRONT WHEEL
DRAIN DIFFERENTIAL OIL
REMOVE FRONT AXLE HUB GREASE CAP
REMOVE FRONT AXLE HUB NUT
REMOVE FRONT SPEED SENSOR LH
DISCONNECT TIE ROD END SUB-ASSEMBLY LH
DISCONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
INSPECT FRONT DRIVE SHAFT ASSEMBLY LH
Front Drive Shaft Assembly -- Removal |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 2. DRAIN DIFFERENTIAL OIL |
| 3. REMOVE FRONT AXLE HUB GREASE CAP |
Using a screwdriver and hammer, remove the grease cap.
- NOTICE:
- Do not damage the axle hub.
| 4. REMOVE FRONT AXLE HUB NUT |
Remove the cotter pin and adjusting cap.
Remove the axle hub nut.
| 5. REMOVE FRONT SPEED SENSOR LH |
Remove the bolt and speed sensor.
Disconnect the 2 clamps.
Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.
| 6. DISCONNECT TIE ROD END SUB-ASSEMBLY LH |
Remove the cotter pin and nut.
Using SST, disconnect the tie rod end from the steering knuckle.
- SST
- 09628-62011
| 7. DISCONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH |
Remove the 2 bolts and disconnect the suspension arm from the steering knuckle.
| 8. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
Using SST, tap out the drive shaft.
- SST
- 09520-01010
09520-24010(09520-32040)
- NOTICE:
- Be careful not to damage the oil seal.
| 9. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH |
*1: Check that there is no excessive play in the outboard joint.
*2: Check that the inboard joint slides smoothly in the thrust direction.
*3: Check that there is no excessive play in the radial direction of the inboard joint.
*4: Check the boots for damage.
