DTC P060E 2ZR-FXE

DTC P060E Internal Control Module Throttle Position Performance

Monitor description

Monitor strategy

Typical enabling conditions

Typical malfunction thresholds

Confirmation driving pattern

Inspection procedure

Read output dtc (dtc p060e)

Monitor description

The ECM monitors the input signals of the No. 1 throttle position sensor. When the ECM monitors the input signal of the No. 1 throttle position sensor, if the input signal and control signal deviate, the DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060E Either condition is met (1 trip detection logic):
  1. There is an ECM main CPU error.
  2. There is an ECM sub CPU error.
 ECM

Monitor strategy

Required sensors/Components (Main) ECM
Frequency of operation Continuous

TYPICAL ENABLING CONDITIONS

DMA communication error Not detected

TYPICAL MALFUNCTION THRESHOLDS

When one of the following conditions is met: Condition 1 or 2
1. Difference of main throttle position and sub throttle position 0.3 V or higher
2. Value of main brake switch signal and sub brake switch signal Different

Confirmation driving pattern

  1. Turn the power switch off.
  2. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) auxiliary battery terminal.
  4. Turn the power switch on (IG) and wait for 10 seconds or more.

Inspection procedure

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work .

1.READ OUTPUT DTC (DTC P060E)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Clear the DTCs .

  1. Turn the power switch off.

  1. Turn the tester off.

  1. Disconnect the tester.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Connect the tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result
    Result Proceed to
    DTC is not output A
    DTC P060E is output B
  B  
REPLACE ECM
 
A  
   
CHECK FOR INTERMITTENT PROBLEMS