Toyota
Camry ACV40 GSV40
Repair Manual
2Gr-Fe Engine Control System
Sfi System
SFI SYSTEM > MIL Circuit
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to the ON position, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.The MIL operation can be checked visually: When the ignition switch is first turned to the ON position, the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.
WIRING DIAGRAM

INSPECTION PROCEDURE
Perform troubleshooting in accordance with the table below.
- Result:
Condition Proceed to MIL remains ON A MIL does not illuminate B
| Go to step 5 | |||
| A | |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester ON.
Select the following menu items: Powertrain / Engine / DTC.
Check if any DTCs have been stored. Note down any DTCs.
Clear the DTCs (Click here).
Check if the MIL goes off.
- Standard:
- MIL goes off.
| REPAIR CIRCUITS INDICATED BY OUTPUT DTCS | |||
| NG | |
![]() |

Disconnect the A24 (RHD) or A55 (LHD) ECM connector.
Turn the ignition switch to the ON position.
Check that the MIL is not illuminated.
- OK:
- MIL is not illuminated.
Reconnect the ECM connector.
| REPLACE ECM (Click here) | |||
| NG | |
![]() |

Disconnect the A24 (RHD) or A55 (LHD) ECM connector.
Disconnect the F2 combination meter connector.
Measure the resistance.
- Standard resistance (Check for short):
- RHD:
Tester Connection Specified Condition W (A24-24) or CHK (F2-4) - Body ground 10 kΩ or higher - LHD:
Tester Connection Specified Condition W (A55-24) or CHK (F2-4) - Body ground 10 kΩ or higher
Reconnect the ECM connector.
Reconnect the combination meter connector.
| REPAIR OR REPLACE COMBINATION METER ASSEMBLY | |||
| NG | |
![]() | |
| REPAIR OR REPLACE HARNESS OR CONNECTOR | |
Check if the MIL is illuminated when the ignition switch is turned to the ON position.
- OK:
- MIL is illuminated.
| SYSTEM OK | |||
| NG | |
![]() |
Turn the ignition switch to the ON position.
Start the engine.
- Result:
Result Proceed to Engine starts A Engine does not start* B
- HINT:
- *: The intelligent tester cannot communicate with the ECM.
| GO TO VC OUTPUT CIRCUIT (Click here) | |||
| A | |
![]() |
Check the MIL circuit (Click here).
| REPAIR OR REPLACE COMBINATION METER ASSEMBLY | |||
| OK | |
![]() | |
| CHECK AND REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM) | |



