Front Seat Inner Belt Assembly (For Sedan) Removal

Vehicle Interior. Yaris. Ncp93, 131
Seat Belt. Yaris. Ncp93, 131

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  3. REMOVE FRONT SEAT ASSEMBLY

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY

Front Seat Inner Belt Assembly (For Sedan) -- Removal


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (YARIS_NCP93 RM000000KT10D1X.html).
NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.
HINT:
The procedure described below is for the driver side. Use the same procedure for both the front passenger and driver sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    Yaris. Ncp93, 131.Seat Belt.Seat Belt Warning System (For Sedan).Front Seat Inner Belt Assembly (For Sedan) Removal

  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.



3. REMOVE FRONT SEAT ASSEMBLY


    Yaris. Ncp93, 131.Seat Belt.Seat Belt Warning System (For Sedan).Front Seat Inner Belt Assembly (For Sedan) Removal

  1. w/Front passenger airbag:

    1. Using a clip remover, remove the clamp.

    2. Slide the slider and disconnect the airbag connector.

    3. Disconnect the buckle switch connector.



  1. w/o Front passenger airbag:



      Yaris. Ncp93, 131

    1. Disconnect the buckle switch connector.



    Yaris. Ncp93, 131

  1. Move the front seat to its most rearward position.

  1. Using "TORX" socket wrench E10, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using "TORX" socket wrench E10, remove the 2 bolts from the rear side.

  1. Remove the front seat.



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    Yaris. Ncp93, 131

  1. for Driver Side:

    1. Disconnect the seat position sensor connector.

    2. Using a clip remover, remove the connector.

    3. Using a clip remover, remove the clamp.

    4. Remove the clamp.



    Yaris. Ncp93, 131

  1. for Front Passenger Seat:

    1. Using a clip remover, remove the connector.

    2. Using a clip remover, remove the clamp.

    3. Remove the clamp.



    Yaris. Ncp93, 131

  1. Remove the wire harness from the claw of the front seat cushion inner shield.

  1. Remove the nut and the front seat inner belt.