Vehicle Interior. Yaris. Ncp93, 131
Supplemental Restraint Systems. Yaris. Ncp93, 131
Curtain Shield Airbag Assembly (For Hatchback 5 Door) -- Installation |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10EAX.html).
| 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install 6 new clips and 6 new spacers to the curtain shield airbag assembly as shown in the illustration.
Text in illustration *1 Clip *2 Pin *3 Spacer *4 Airbag *5 Body Side - HINT:
- Do not push in the pin.
- Make sure that the clips are installed in the correct direction.
- Make sure that the spacers are installed properly, in the correct direction, and that they are not damaged.
 |
Engage hook A by inserting it while sliding in the direction shown in the illustration, then engage hook B by inserting it from the direction shown in the illustration, and temporarily install the curtain shield airbag RH with the bolt.
Text in illustration *1 Hook A *2 Hook B
 |
Push in the 6 pins to install the 6 clips and the curtain shield airbag assembly to the body panel as shown in the illustration.
Text in illustration *1 Pin *2 Clip *3 Airbag *4 Body Panel - NOTICE:
- Make sure that the pins of the clips are pushed in firmly.
 |
Mark the clips.
- HINT:
- Mark the clips to make sure that they are not reused.
Tighten the bolt.
- Torque:
- 14 N*m{143 kgf*cm, 10 ft.*lbf}
- NOTICE:
- Do not twist the curtain shield airbag assembly when installing it.
Connect the airbag connector.
Text in illustration *1 Locking Button
 |
Push in the locking button.
- NOTICE:
- Do not damage the airbag wire harness when connecting the airbag connector.
- Securely lock the locking button.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{55 kgf*cm, 48 in.*lbf}
| 4. INSPECT SRS WARNING LIGHT |