Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

Vehicle Exterior. Yaris. Ncp93, 131
Window Glass. Yaris. Ncp93, 131

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (POWER SOURCE)

INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - POWER WINDOW REGULATOR MOTOR)

INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY

CHECK HARNESS AND CONNECTOR (REGULATOR MASTER SWITCH - REGULATOR SWITCH)

INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (REAR RH SWITCH)

POWER WINDOW CONTROL SYSTEM (for Sedan) - Rear Power Window RH does not Operate with Rear Power Window Switch RH


DESCRIPTION

If the rear RH side manual UP/DOWN function does not operate, a malfunction may exist in the power window regulator motor, power window regulator switch, power window regulator master switch or wire harness.

WIRING DIAGRAM


Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (POWER SOURCE)


    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the H1 power window regulator switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    H1-3 (B) - Body ground
    		Ignition switch ON
    		11 to 14 V

  1. Reconnect the power window regulator switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Remove the power window regulator switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 - 2
    3 - 4
    		UP
    		Below 1 Ω
    1 - 2
    4 - 5
    		OFF
    		Below 1 Ω
    1 - 3
    4 - 5
    		DOWN
    		Below 1 Ω

  1. Reinstall the power window regulator switch assembly.



NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (YARIS_NCP93 RM0000029XG00LX.html)
OK


3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - POWER WINDOW REGULATOR MOTOR)


    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the H1 power window regulator switch assembly connector.

  1. Disconnect the H2 power window regulator motor assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    H1-4 (U) - H2-1 (U)
    		Always
    		Below 1 Ω
    H1-4 (U) or H2-1 (U) - Body ground
    		Always
    		10 kΩ or higher
    H1-1 (D) - H2-2 (D)
    		Always
    		Below 1 Ω
    H1-1 (D) or H2-2 (D) - Body ground
    		Always
    		10 kΩ or higher

  1. Reconnect the power window regulator switch assembly connector.

  1. Reconnect the power window regulator motor assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY


    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Remove the power window regulator motor assembly.

  1. Apply battery voltage to connector terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    		Motor gear rotates counterclockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    		Motor gear rotates clockwise

  1. Reinstall the power window regulator motor assembly .



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (YARIS_NCP93 RM0000029XM00KX.html)
OK


5.CHECK HARNESS AND CONNECTOR (REGULATOR MASTER SWITCH - REGULATOR SWITCH)


    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the G1 power window regulator master switch assembly connector.

  1. Disconnect the H1 power window regulator switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    G1-10 (U) - H1-5 (SU)
    		Always
    		Below 1 Ω
    G1-10 (U) or H1-5 (SU) - Body ground
    		Always
    		10 kΩ or higher
    G1-18 (D) - H1-2 (SD)
    		Always
    		Below 1 Ω
    G1-18 (D) or H1-2 (SD) - Body ground
    		Always
    		10 kΩ or higher

  1. Reconnect the power window regulator master switch assembly connector.

  1. Reconnect the power window regulator switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (REAR RH SWITCH)

  1. Remove the power window regulator master switch assembly.



    Yaris. Ncp93, 131.Window Glass.Power Window Control System (For Sedan).Power Window Control System (For Sedan) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Measure the resistance according to the value(s) in the table below.

    1. Remove the power window regulator master switch assembly.

    2. Measure the resistance of the switch when the switch is operated.

      Standard resistance:
      Tester Connection
      		Window Lock Switch Condition
      		Power Window Switch Condition
      		Specified Condition
      1 (E) - 18 (D)
      6 (B) - 10 (U)
      		OFF
      		UP
      		Below 1 Ω
      1 (E) - 10 (U)
      1 (E) - 18 (D)
      		OFF
      		OFF
      		Below 1 Ω
      1 (E) - 10 (U)
      6 (B) - 18 (D)
      		OFF
      		DOWN
      		Below 1 Ω
      1 (E) - 18 (D)
      		ON
      		UP
      		10 kΩ or higher
      6 (B) - 10 (U)
      		Below 1 Ω
      10 (U) - 18 (D)
      		ON
      		OFF
      		Below 1 Ω
      1 (E) - 10 (U)
      		ON
      		DOWN
      		10 kΩ or higher
      6 (B) - 18 (D)
      		Below 1 Ω

    3. Reinstall the power window regulator master switch assembly.



NG
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (YARIS_NCP93 RM0000029XP00JX.html)
OK

GO TO POWER WINDOWS DO NOT OPERATE AT ALL (YARIS_NCP93 RM0000010ZD02XX.html)