Vehicle Interior. Yaris. Ncp93, 131
Supplemental Restraint Systems. Yaris. Ncp93, 131
Center Airbag Sensor Assembly (For Hatchback) -- Installation |
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10EAX.html).
| 1. INSTALL AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Check that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor assembly will cause the airbag to deploy.
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Install the airbag sensor assembly with the 3 bolts.
- Torque:
- 17.5 N*m{178 kgf*cm, 13 ft.*lbf}
- NOTICE:
- Do not use an airbag sensor assembly that has been dropped.
- Do not subject the airbag sensor assembly to any impact or force.
- Check that the carpet does not interfere with the installation plane.
Check that there is no looseness by shaking the airbag sensor assembly.
Connect the connector holder to lock the lever.
- NOTICE:
- Check that the lever is locked.
Text in Illustration *1 Lever
 |
Check that the drip-proof sheet has not been removed and does not cut into the connectors.
Text in Illustration *1 Drip-proof Sheet
 |
| 2. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{55 kgf*cm, 48 in.*lbf}
| 4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (for Hatchback with VSC/Built-in Type Yaw Rate Sensor) |
| 5. INSPECT SRS WARNING LIGHT |