Curtain Shield Airbag Assembly (For Hatchback 3 Door) Removal

Vehicle Interior. Yaris. Ncp93, 131
Supplemental Restraint Systems. Yaris. Ncp93, 131

  1. PRECAUTION

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE ROOF HEADLINING ASSEMBLY

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

Curtain Shield Airbag Assembly (For Hatchback 3 Door) -- Removal


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (YARIS_NCP93 RM000000KT10EAX.html).
HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (YARIS_NCP93 RM00000482M008X.html).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


3. REMOVE ROOF HEADLINING ASSEMBLY
(YARIS_NCP93 RM0000036M5010X.html)


4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY


    Yaris. Ncp93, 131.Supplemental Restraint Systems.Airbag System (For Sedan).Curtain Shield Airbag Assembly (For Hatchback 3 Door) Removal

  1. Using a thin-bladed screwdriver with its tip wrapped with protective tape, release the locking button.

    Text in Illustration
    *1
    		Protective Tape
    *2
    		Locking Button

  1. Disengage the airbag connector.



    Yaris. Ncp93, 131.Supplemental Restraint Systems.Airbag System (For Sedan).Curtain Shield Airbag Assembly (For Hatchback 3 Door) Removal

  1. Using a clip remover, pull up the 6 pins.

    Text in Illustration
    *1
    		Pin
    *2
    		Clip
    *3
    		Airbag
    *4
    		Body Panel


    Yaris. Ncp93, 131.Supplemental Restraint Systems.Airbag System (For Sedan).Curtain Shield Airbag Assembly (For Hatchback 3 Door) Removal

  1. Using needle-nose pliers, disengage each 2 claws to disconnect the 6 clips and curtain shield airbag from the body panel as shown in the illustration.

    Text in illustration
    *1
    		Clip
    *2
    		Airbag
    *3
    		Body Panel


    Yaris. Ncp93, 131

  1. Remove the bolt.



    Yaris. Ncp93, 131.Supplemental Restraint Systems.Airbag System (For Sedan).Curtain Shield Airbag Assembly (For Hatchback 3 Door) Removal

  1. Disengage hook A in the direction shown in the illustration, then disengage hook B by sliding in the direction shown in the illustration, and remove the curtain shield airbag assembly.

    Text in illustration
    *1
    		Hook A
    *2
    		Hook B

  1. Remove the 6 clips and 6 spacers from the curtain shield airbag assembly.

    NOTICE:
    If clips and spacers are removed, always replace them with new ones even though they may not appear to be damaged.