Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

Restraints. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
Supplemental Restraint System. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK CONNECTION OF CONNECTOR

CHECK FRONT AIRBAG SENSOR RH CIRCUIT (OPEN)

CHECK FRONT AIRBAG SENSOR RH CIRCUIT (SHORT)

CHECK FRONT AIRBAG SENSOR RH CIRCUIT (TO B+)

CHECK FRONT AIRBAG SENSOR RH CIRCUIT (TO GROUND)

CHECK FRONT AIRBAG SENSOR RH

CHECK ENGINE ROOM MAIN WIRE (OPEN)

CHECK ENGINE ROOM MAIN WIRE (SHORT)

CHECK ENGINE ROOM MAIN WIRE (TO B+)

CHECK ENGINE ROOM MAIN WIRE (TO GROUND)

DTC B1602/83 Lost Communication with Front Satellite Sensor Bus RH

DTC B1603/83 Front Satellite Sensor Bus RH Initialization Incomplete

DTC B1612/83 Lost Communication with Front Airbag Sensor RH

DTC B1613/83 Front Airbag Sensor RH Initialization Incomplete


DESCRIPTION

The front airbag sensor RH consists of the diagnostic circuit and the frontal deceleration sensor.
If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1602/83, B1603/83, B1612/83 or B1613/83 is recorded when a malfunction is detected in the front airbag sensor RH circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1602/83
B1603/83
B1612/83
B1613/83
When one of following conditions is met:
  1. Center airbag sensor detects line short signal, open signal, short to ground signal or short to B+ signal in front airbag sensor RH circuit for 2 seconds
  2. Front airbag sensor RH malfunction
  3. Center airbag sensor malfunction
  1. Instrument panel wire
  2. Engine room main wire
  3. Front airbag sensor RH
  4. Center airbag sensor

WIRING DIAGRAM


Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh


INSPECTION PROCEDURE

1.CHECK CONNECTION OF CONNECTOR

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the center airbag sensor and the front airbag sensor RH.

    OK:
    The connectors are connected.


NG
CONNECT CONNECTOR
OK


2.CHECK FRONT AIRBAG SENSOR RH CIRCUIT (OPEN)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Disconnect the connectors from the center airbag sensor and the front airbag sensor RH.

  1. Using a service wire, connect A45-2 (+SR) and A45-1 (-SR) of connector E.

    NOTICE:
    Do not forcibly insert a service wire into the terminals of the connector when connecting.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    E49-29 (+SR) - E49-27 (-SR)
    		Below 1 Ω


NG
Go to step 7
OK


3.CHECK FRONT AIRBAG SENSOR RH CIRCUIT (SHORT)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Disconnect the service wire from connector E.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    E49-29 (+SR) - E49-27 (-SR)
    		1 MΩ or higher


NG
Go to step 8
OK


4.CHECK FRONT AIRBAG SENSOR RH CIRCUIT (TO B+)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Specified Condition
    E49-29 (+SR) - Body ground
    		Below 1 V
    E49-27 (-SR) - Body ground
    		Below 1 V


NG
Go to step 9
OK


5.CHECK FRONT AIRBAG SENSOR RH CIRCUIT (TO GROUND)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    E49-29 (+SR) - Body ground
    		1 MΩ or higher
    E49-27 (-SR) - Body ground
    		1 MΩ or higher


NG
Go to step 10
OK


6.CHECK FRONT AIRBAG SENSOR RH
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Connect the connectors to the center airbag sensor.

  1. Interchange the front airbag sensor RH and LH, and connect the connectors to them.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs (RAV4_ACA30 RM000000XFE06SX.html).

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check the DTCs (RAV4_ACA30 RM000000XFE06SX.html).

    Result
    Result
    		Proceed to
    DTC B1602/83, B1603/83, B1612/83, B1613/83, B1607/84, B1608/84, B1617/84 and B1618/84 are not output.
    		A
    DTC B1602/83, B1603/83, B1612/83, and B1613/83 are output
    		B
    B1607/84, B1608/84, B1617/ 84 and B1618/84 are output
    		C
    HINT:
    DTCs other than DTC B1602/83, B1603, B1612/83, B1613/83, B1607/84, B1608/84, B1617/84 and B1618/84 may be output at this time, but they are not related to this check.


B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY

C
REPLACE FRONT AIRBAG SENSOR RH
A

USE SIMULATION METHOD TO CHECK

7.CHECK ENGINE ROOM MAIN WIRE (OPEN)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Disconnect the engine room main wire connector from the instrument panel wire.

  1. Disconnect the service wire from connector E.

  1. Disconnect the engine room main wire connector from the instrument panel wire.

  1. Using a service wire, connect AE9-2 (+SR) and AE9-1 (-SR) of connector D.

    NOTICE:
    Do not forcibly insert a service wire into the terminals of the connector when connecting.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    A45-2 (+SR) - A45-1 (-SR)
    		Below 1 Ω


NG
REPAIR OR REPLACE ENGINE ROOM MAIN WIRE
OK

REPAIR OR REPLACE INSTRUMENT PANEL WIRE

8.CHECK ENGINE ROOM MAIN WIRE (SHORT)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Disconnect the engine room main wire connector from the instrument panel wire.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    AE9-1 (+SR) - AE9-2 (-SR)
    		1 MΩ or higher


NG
REPAIR OR REPLACE ENGINE ROOM MAIN WIRE
OK

REPAIR OR REPLACE INSTRUMENT PANEL WIRE

9.CHECK ENGINE ROOM MAIN WIRE (TO B+)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Disconnect the engine room main wire connector from the instrument panel wire.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Specified Condition
    AE9-1 (+SR) - Body ground
    		Below 1 V
    AE9-2 (-SR) - Body ground
    		Below 1 V


NG
REPAIR OR REPLACE ENGINE ROOM MAIN WIRE
OK

REPAIR OR REPLACE INSTRUMENT PANEL WIRE

10.CHECK ENGINE ROOM MAIN WIRE (TO GROUND)
Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35.Supplemental Restraint System.Airbag System. Dtc B1602/83 Lost Communication With Front Satellite Sensor Bus Rh

  1. Disconnect the engine room main wire connector from the instrument panel wire.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    		Specified Condition
    AE9-1 (+SR) - Body ground
    		1 MΩ or higher
    AE9-2 (-SR) - Body ground
    		1 MΩ or higher


NG
REPAIR OR REPLACE ENGINE ROOM MAIN WIRE
OK

REPAIR OR REPLACE INSTRUMENT PANEL WIRE