Rear Speed Sensor (For 4Wd) Installation

Install the sensor (labeled A) with the bolt (labeled B).

Torque:

8.5 N*m{87 kgf*cm, 75 in.*lbf}

NOTICE:

1. Keep the sensor tip and sensor installation hole free from foreign matter.
   
2. To prevent interference with the bearing rotor, do not rotate the sensor body when inserting the sensor body or after inserting the sensor body.
   

Install the sensor clamp (labeled C) with the nut (labeled D).

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the sensor clamps (labeled E) with the 2 nuts (labeled F).

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

NOTICE:

Do not twist the sensor wire when installing the clamps.

Install the sensor clamp (labeled G) with the bolt (labeled H).

Torque:

8.5 N*m{87 kgf*cm, 75 in.*lbf}

NOTICE:

Do not twist the sensor wire when installing the clamp.

Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.

NOTICE:

Make sure the grommet band clamp remains on the outside of the vehicle.

Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.

NOTICE:

1. When pulling out the grommet, do not grip the sensor wire.
   
2. Fix the grommet in place within the range shown in the illustration.
   

Connect the speed sensor connector.

for Short Body:
Install the deck trim side panel LH (RAV4_ACA30 RM000001XUR003X.html).

HINT:

Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.

for Long Body:
Install the deck trim side panel LH (RAV4_ACA30 RM000001XUX003X.html).

HINT:

Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.

w/o VSC:
Check the speed sensor signal (RAV4_ACA30 RM000000ONN01NX.html).

w/ VSC:
Check the speed sensor signal (RAV4_ACA30 RM0000022CZ007X.html).