Wiper And Washer System (W/ Rain Sensor) Washer Motor Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT FUSE (WSH)

INSPECT WINDSHIELD WASHER MOTOR AND PUMP

CHECK WIRE HARNESS (MOTOR - RELAY AND BATTERY)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

1. Remove the WSH fuse from the instrument panel junction block.
   

2. Measure the resistance of the fuse.
   

   Standard resistance:

   Below 1 Ω
   

1. Remove the washer jar.
   

2. Apply battery voltage to the windshield washer motor connector and check the operation of the windshield washer motor assembly.
   

   OK:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2	Washer fluid flows from washer jar

   HINT:

   The check should be performed with the windshield washer motor and pump installed to the washer jar.

1. Disconnect the A41 motor connector.
   

2. Disconnect the E66 relay connector.
   

3. Measure the voltage of the wire harness side connector.
   

   Standard voltage:

   Tester Connection	Switch Condition	Specified Condition
   A41-1 - Body ground	Ignition switch on (IG)	10 to 14 V

4. Measure the resistance of the wire harness side connectors.
   

   Standard resistance:

   Tester Connection	Specified Condition
   A41-2 - E66-4 (W)	Below 1 Ω