Starter (For 1.3 Kw Type) Removal

Remove the 6 screws, 10 clips and under cover.

Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

NOTICE:

Attempting to detach both front and rear clips at the same time may cause the cover to break.

Remove the 9 clips and radiator support opening cover.

Disconnect the mass air flow meter connector.

Detach the clamp.

Disconnect the No. 2 ventilation hose from the cylinder head cover.

Squeeze the taps of the air cleaner hose clamp, and then disconnect the air cleaner hose from the throttle body.

Detach the 2 hook clamps, and then remove the air cleaner cap and hose.

Remove the bolt and loosen the nut.

Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.

Remove the 2 bolts and disconnect the radiator hose from the front battery bracket.

Detach the 3 wire harness clamps.

Remove the 4 bolts, disconnect the No. 3 engine wire and remove the front battery bracket.

Remove the 2 bolts and battery bracket reinforcement.

Remove the clip and disconnect the control cable from the No. 1 transmission control cable bracket.

Remove the 2 bolts and transmission control cable bracket from the continuously variable transaxle.

Disconnect the terminal cap.

Remove the nut and disconnect the starter wire.

Disconnect the connector.

Remove the 2 bolts and starter.

Remove the flywheel housing side cover from the cylinder block.