Dtc C1Ac1 Master Module Horizontal Axis Misalignment
DESCRIPTION
INSPECTION PROCEDURE
CHECK INSTALLATION CONDITION
PERFORM BEAM AXIS CONFIRMATION
DTC C1AC1 Master Module Horizontal Axis Misalignment |
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.- HINT:
- If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (multi-function switch) on, the blind spot monitor system may store this DTC by mistake.
DTC Code
| DTC Detection Condition
| Trouble Area
|
C1AC1
| When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated.
| Blind spot monitor sensor LH
|
INSPECTION PROCEDURE
- NOTICE:
- When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
| 1.CHECK INSTALLATION CONDITION |
Check the installation condition of the blind spot monitor sensor LH (LandCruiser RM000004RXS025X.html).
- HINT:
- Take the appropriate action in accordance with the result.
| 2.PERFORM BEAM AXIS CONFIRMATION |
Install the rear bumper (LandCruiser RM0000038K202BX.html).
Perform Blind Spot Monitor Beam Axis Confirmation using the GTS (LandCruiser RM000004RXS025X.html).
- OK:
- Blind Spot Monitor Beam Axis Confirmation performs normally.