4Wd Control Ecu -- Removal |
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (LandCruiser RM000003YMD00TX.html).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (LandCruiser RM000003YMF011X.html).
| 3. REMOVE DOOR SCUFF PLATE ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 4. REMOVE COWL SIDE TRIM BOARD RH |
- HINT:
- Use the same procedure described for the LH side.
| 5. REMOVE INSTRUMENT SIDE PANEL RH |
 |
Put protective tape around the instrument side panel.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 5 clips, claw, and 3 guides.
Disconnect the connector and remove the instrument side panel.
| 6. REMOVE INSTRUMENT PANEL ORNAMENT |
 |
Put protective tape around the instrument panel ornament.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 5 clips and remove the instrument panel ornament.
| 7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.
Text in Illustration *A for LHD *B for RHD
| 8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
 |
Remove the 2 bolts <C> and 2 screws <A> or <B>.
Text in Illustration *1 Bolt *2 Screw
Detach the 5 clips and claw.
Disconnect each connector and remove the glove compartment door.
| 9. REMOVE 4 WHEEL DRIVE CONTROL ECU |
 |
Disconnect the 2 connectors.
Remove the bolt and 4 wheel drive control ECU.