CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
CHECK REAR TELEVISION CAMERA ASSEMBLY
REPLACE REAR TELEVISION CAMERA ASSEMBLY
DTC C1622 Open or Short Circuit in Back Camera Signal |
DESCRIPTION
This DTC is stored if the radio and display receiver assembly judges as a result of its self check that the signals or signal lines between the radio and display receiver assembly and the rear television camera assembly are not normal.DTC Code | DTC Detection Condition | Trouble Area |
C1622 | Open or Short Circuit in television camera signal |
|
WIRING DIAGRAM

INSPECTION PROCEDURE
1.CHECK FOR DTC |
Clear the DTCs (LandCruiser RM0000051N601JX.html).
Check for DTCs (LandCruiser RM0000051N601JX.html).
Result Result Proceed to No DTC is output A DTC is output B
|
| ||||
A | ||
|
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY) |
Disconnect the H50 radio and display receiver assembly connector.
Disconnect the X9*1 or v2*2 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- w/ Tire Carrier:
Tester Connection Condition Specified Condition H50-11 (CA+) - X9-6 (CB+) Always Below 1 Ω H50-12 (V+) - X9-3 (CV+) Always Below 1 Ω H50-23 (CGND) - X9-5 (CGND) Always Below 1 Ω H50-24 (V-) - X9-2 (CV-) Always Below 1 Ω H50-11 (CA+) - Body ground Always 10 kΩ or higher H50-12 (V+) - Body ground Always 10 kΩ or higher H50-23 (CGND) - Body ground Always 10 kΩ or higher H50-24 (V-) - Body ground Always 10 kΩ or higher - w/o Tire Carrier:
Tester Connection Condition Specified Condition H50-11 (CA+) - v2-6 (CB+) Always Below 1 Ω H50-12 (V+) - v2-3 (CV+) Always Below 1 Ω H50-23 (CGND) - v2-5 (CGND) Always Below 1 Ω H50-24 (V-) - v2-2 (CV-) Always Below 1 Ω H50-11 (CA+) - Body ground Always 10 kΩ or higher H50-12 (V+) - Body ground Always 10 kΩ or higher H50-23 (CGND) - Body ground Always 10 kΩ or higher H50-24 (V-) - Body ground Always 10 kΩ or higher
|
| ||||
OK | |
3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition H50-23 (CGND) - Body ground Always Below 1 Ω H50-24 (V-) - Body ground Always Below 1 Ω
![]() |
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection Switch Condition Specified Condition H50-11 (CA+) - Body ground Ignition switch ON 5.5 to 7.05 V
*a | Component with harness connected (Radio and Display Receiver Assembly) |
Result | Proceed to |
OK | A |
NG (w/ Navigation System) | B |
NG (w/o Navigation System) | C |
|
| ||||
|
| ||||
A | |
4.CHECK REAR TELEVISION CAMERA ASSEMBLY |
Using an oscilloscope, check the waveform.
Text in Illustration *a Component with harness connected
(Radio and Display Receiver Assembly)*b Waveform 1 *c Waveform 2 *d Synchronized Signal *e Video Waveform - - Measurement Condition Item Content Tester Connection H50-12 (V+) - H50-23 (CGND) Tool Setting 200 mV/DIV., 50 μs/DIV. Condition - Waveform 1: Ignition switch ON, camera lens not covered, displaying an image
- Waveform 2: Ignition switch ON, camera lens covered, blacking out screen
- OK:
- Waveform is as shown in illustration.
- HINT:
- The video waveform changes according to the image sent by the rear television camera assembly.
- Waveform 1: Ignition switch ON, camera lens not covered, displaying an image
|
| ||||
OK | ||
|
5.REPLACE REAR TELEVISION CAMERA ASSEMBLY |
Replace the rear television camera assembly with a new or normally functioning one.
- w/ Tire Carrier: LandCruiser RM00000470R008X.html
- w/o Tire Carrier: LandCruiser RM00000470U00MX.html
- w/ Tire Carrier: LandCruiser RM00000470R008X.html
NEXT | |
6.CHECK FOR DTC |
Clear the DTCs (LandCruiser RM0000051N601JX.html).
Check for DTCs (LandCruiser RM0000051N601JX.html).
Result Result Proceed to OK A NG (w/ Navigation System) B NG (w/o Navigation System) C
|
| ||||
|
| ||||
A | ||
|