Television Camera (For Side) Removal

Remove the outer rear view mirror (LandCruiser RM000000W1P057X.html).

Push the upper part of the mirror surface and tilt it.

Using a moulding remover, detach the 4 claws and separate the outer rear view mirror glass from the mirror body.

HINT:

Apply protective tape to the outer rear view mirror to prevent it from being damaged.

Disconnect the connectors and remove the mirror glass.

Using 2 screwdrivers, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Insert a screwdriver into the slot as shown in the illustration and push on the outer mirror body to create a space between the outer mirror body and outer mirror cover.

NOTICE:

Be careful not to break the ribs.

HINT:

Tape the screwdriver tip before use.

Insert a moulding remover into the space made between the outer mirror body and outer mirror cover.

NOTICE:

Do not insert the moulding remover more than 4 mm (0.157 in.).

HINT:

Tape the moulding remover before use.

Slide the moulding remover downwards as shown in the illustration to detach the 2 claws.

NOTICE:

1. Do not insert the moulding remover more than 4 mm (0.157 in.).
   
2. Do not slide the moulding remover past the point approximately 40 mm (1.57 in.) from the bottom edge of the outer mirror cover as the outer mirror body will become damaged.
   

Standard:

Area	Specified Condition
a	40.0 mm (1.57 in.)

Remove the moulding remover.

Insert a moulding remover between the outer mirror cover and outer mirror body as shown in the illustration and detach the claw.

Using a screwdriver, detach the claw.

Detach the 2 claws and remove the outer mirror cover.

NOTICE:

When removing the cover, be careful not to damage the side turn signal light assembly or cover.

Remove the 3 screws and light.

Disconnect the connector.

Remove the tape.

Remove the screw, detach the 4 claws and remove the rubber base.

HINT:

It is not necessary to completely remove the rubber base. Slightly move the rubber base so that the lower mirror cover can be removed in a later step.

Remove the lower mirror cover.

1. Put protective tape around the lower mirror cover.
   

   Text in Illustration

   *1	Protective Tape





2. Using a screwdriver, detach the claw.
   

   Text in Illustration

   *1	Protective Tape





3. Using a screwdriver, detach the claw.
   

   Text in Illustration

   *1	Protective Tape





4. Using a screwdriver, detach the claw to create a space between the lower mirror cover and mirror body as shown in the illustration.
   

   Text in Illustration

   *1	Protective Tape





5. Insert a screwdriver as shown in the illustration.
   

   Text in Illustration

   *1	Protective Tape





6. Detach the claw to create a space between the lower mirror cover and mirror body as shown in the illustration.
   

   Text in Illustration

   *1	Protective Tape





7. While moving the lower mirror cover back and forth in the directions of the arrows in the illustration, detach the 3 claws and remove the lower mirror cover.
   

Using a T25 "TORX" socket wrench, remove the 3 screws.

Remove the 5 screws.

Using a moulding remover, open the mirror body as shown in the illustration.

Using a moulding remover, detach the 2 claws.

NOTICE:

Be careful not to break the claw shown in the part of the illustration labeled A.

Using a screwdriver, disconnect the connector.

NOTICE:

When disconnecting the connector, be careful not to damage it.

HINT:

Tape the screwdriver tip before use.

Remove the 3 screws and side television camera.